A.It tells the router or switch to try establish an SSH connection first and if that fail to use telnet.
B.It configures a cisco network device to use the SSH protocol on incoming communications via the virtual terminal ports.
C.It allows seven failed login attempts before the VTY lines are temporarily shutdown.
D.It configures the virtual terminal lines with the password 030752180500.
E.It configures SSH globally for all logins.
第1题:
Refer to the exhibit. The partial configuration for an OSPF ASBR and an Area 0 ABR is shown. Assume the OSPF configurations throughout the network are operable. Which statement about these configurations is true? ()

A. The ASBR route - maps are basically useless, because there are no deny prefix - lists.
B. LSA Type 5s wil l not be received by the ABR from the ASBR.
C. The OSPF backbone will not learn any RFC 1918 addresses.
D. The matched prefix - list addresses will be given a metric of 255, which is essentially unreachable.
第2题:

A. Additional DHCP options will be imported from another DHCP server.
B. The DHCP server pools need to be bound to an interface to operate.
C. This configuration will provide IP configuration information to two different su bnets.
D. Additional DCHP option information needs to be imported from another DHCP server.
E. If the router hands out all the addresses in pool 1, then it will supply addresses from pool 2.
第3题:
A.There is a mismatch in encapsulation types
B.The wrong type of cable is connected to the interface
C.The interface has been configured with the shutdown command
D.The interface is not receiving any keepalives
E.The interface needs to be configured as a DTE device
F.There is no encapsulation type configured
第4题:
Refer to the exhibit. A network associate has configured OSPF with the command:City(config-router) network 192.168.12.64 0.0.0.63 area 0After completing the configuration, the associate discovers that not all the interfaces are participating in OSPF. Which three of the interfaces shown in the exhibit will participate in OSPF according to this configuration statement? ()

A.FastEthernet0 /0
B.FastEthernet0 /1
C.Serial0/0
D.Serial0/1.102
E.Serial0/1.103
F.Serial0/1.104
第5题:

A.The Router1 WAN port is configured as a trunking port.
B.The Router1 port connected to Switch1 is configured using subinterfaces.
C.The Router1 port connected to Switch1 is configured as 10 Mbps.
D.The Switch1 port connected to Router1 is configured as a trunking port.
E.The Switch1 port connected to Host B is configured as an access port.
F.The Switch1 port connected to Hub1 is configured as full duplex.
第6题:
第7题:
Refer to the exhibit.What is the reason that the interface status is “administratively down,line protocol down”?()
第8题:
Refer to the exhibit.What is the effect of the configuration that is shown?()
第9题:
The number of collision domains would decrease.
The number of collision domains would increase.
The number of broadcast domains would remain the same.
The number of collision domains would remain the same.
The number of broadcast domains would increase.
第10题:
It tells the router or switch to try establish an SSH connection first and if that fail to use telnet.
It configures a cisco network device to use the SSH protocol on incoming communications via the virtual terminal ports.
It allows seven failed login attempts before the VTY lines are temporarily shutdown.
It configures the virtual terminal lines with the password 030752180500.
It configures SSH globally for all logins.
第11题:
The traffic will be rejected
The traffic will be dropped
The traffic will be forwarded
The traffic will be policed
第12题:
The DHCP pool needs to have an import all statement.
The DHCP pool is missing an option 150 ip 10.59.138.1 statement.
The DHCP pool is missing an option 139 ip 10.59.138.1 statement
The DHCP pool is missing a dns-server 10.59.138.1 statement.
第13题:
Refer to the exhibit. A partial routing configuration is shown. Complete the configuration so that only the default - network is redistributed from EIGRP 190 into EIGRP 212. Which ACL statement completes the configuration correctly? ()

A. access - list 100 permit ip 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0 .0
B. access - list 100 permit ip host 0.0.0.0 any
C. access - list 100 permit ip any host 0.0.0.0
D. A default -network cannot be redistributed between routing processes.
第14题:

A.The Seria l0/0interface is passing traffic.
B.The DLCI 100 was dynamic allyallocated by the router
C.The Seria l0/0 interf aceacquired the IP address of 172.16.3.1 from a DHCP server
D.The DLCI 100 will be dynamically changed as required to adapt to changes in the Frame Relay cloud
E.The mapping between DLCI 100 and the end station IP address 172.16.3.1 was learned through Inverse ARP
第15题:

A.data link layer
B.application layer
C.access layer
D.session layer
E.network layer
第16题:

A.The number of collision domains would decrease.
B.The number of collision domains would increase.
C.The number of broadcast domains would remain the same.
D.The number of collision domains would remain the same.
E. The number of broadcast domains would increase.
第17题:

A.No configuration file was found in NVRAM.
B.No configuration file was found in flash.
C.No configuration file was found in the PCMCIA card.
D.Configuration file is normal and will load in 15 seconds.
第18题:
Refer to the exhibit. Which two statements are true about the partial configuration that is shown?()
第19题:
Refer to the exhibit. The DHCP configuration that is shown is configured on a Cisco router. Whichstatement is true?()
第20题:
data link layer
application layer
access layer
session layer
network layer
第21题:
The candidate configuration is a temporary configuration that might become the active configuration.
A candidate configuration is initially populated with the configuration currently active on the system.
Changes to the candidate configuration take effect immediately.
The candidate configuration becomes the active configuration after a system reboot.
The configure private command allows concurrent editing of a candidate configuration by multiple users.
第22题:
There is a mismatch in encapsulation types
The wrong type of cable is connected to the interface
The interface has been configured with the shutdown command
The interface is not receiving any keepalives
The interface needs to be configured as a DTE device
There is no encapsulation type configured
第23题:
The router will distribute IP addresses from pool 1 until its addresses are exhausted. Then therouter will begin distributing addresses from pool 2
The configuration is invalid because the DHCP options are global configuration commands
The configuration is incomplete until the DHCP pools are bound to the appropriate interface orinterfaces
The router will choose which pool to use based upon the interface the DHCP request wasreceived on
第24题:
The network administrator faled to save the configuration.
The configuration register is set to 0x2100.
The boot system flash command is missing from the configuration.
The configuraiton register is set to 0x2102.
The router is configured with the boot system startup command.