Resolution
Colors
Dots per inch
Refresh rate
第1题:
After installing a new video card, the computer loads Windows and continuously reboots. Which of the following would be the FIRST step that a technician should take?()
第2题:
A customer reports to Karen, a technician, that he is experiencing problems with the display after his computer is fully booted but reports seeing the BIOS splash screen during boot. Which of the following would MOST likely be the cause?()
第3题:
A technician(技术) has a current baseline(基准线) and is told to install additional(添加) memory and a faster NIC card. At which point in time should the next baseline be run?()
第4题:
After a technician installs a new CMOS battery on a motherboard, which of the following will thetechnician have to change? ()
第5题:
A technician installs a new sound card but no sound can be heard. Which of the following utilities can be used to see an error?()
第6题:
A technician has replaced a video card with another manufacturer’s video card. The driverinstallation does not complete. Which of the following steps should the technician take FIRST?()
第7题:
Press the appropriate function + monitor key.
Adjust the BIOS settings for external display.
Replace the video card on the laptop.
Update video drivers for the video card.
第8题:
Roll back the driver.
Install the original video card and reboot.
Delete the monitor.
Remove the video card and reboot.
第9题:
Replace the video card with a compatible one.
Check the Windows XP Hardware Compatibility List.
Verify the boot order in the BIOS.
Install Windows XP RC2 first, then upgrade to Windows XP Media Center.
第10题:
Firmware version
System date/time
Bus speeds
Jumper settings
第11题:
Run CHKDSK
Boot to ERD
Run MSCONFIG
Go into Safe Mode
第12题:
The display is defective.
The video card needs to be flashed.
The internal adapter has not been disabled.
The new video card is defective.
第13题:
A technician installs a new video card in a desktop with onboard video. The technician boots the unit but sees no display. The monitor power light is on and the OS seems to be loading. Which ofthe following is the MOST likely cause?()
第14题:
After a technician installs a video card, which of the following should the technician configure NEXT?()
第15题:
A laptop will not output to a connected projector. Which of the following steps should a technician take FIRST?()
第16题:
A technician is troubleshooting a monitor displaying a blank screen and the power indicator light ison. Which of the following should the technician do next?()
第17题:
A user is reporting that a PC will suddenly shut down without warning. The PC boots up with no problems, but after using the PC for a short time, the PC turns off. Which of the following components should the technician check?() (Select TWO).
第18题:
Reboot the computer
Remove the drive and reinstall
Install the device driver
Flash the BIOS
第19题:
After the memory is installed
Before the upgrade is performed
After the NIC is installed
After the upgrades are performed
第20题:
Reseat all power connections.
Remove the CMOS battery.
Install the graphics card.
Ground to the case.
第21题:
MSCONFIG
Device Manager
DXDIAG
REGEDIT
第22题:
Test the computer with a known-good monitor.
Check if the monitor is still covered under the manufacturer’s warranty.
Replace the monitor’s power cord with a known-good power cord.
Swap out the computer’s video card.
第23题:
The video cable is incorrectly attached.
A corrupted or incorrect video driver is installed.
An incorrect video card is installed in the computer.
The video card is defective and needs to be replaced.